A Tight Fit But Works Fine
This agitator belt on my Hoover Dimension breaks every few years or so, so I thought I would stock up and save a few bucks on future purchases. The belts arrived on-time as promised. I noticed they were significantly smaller than the belt I was replacing, which concerned me for a bit, but since the product number matched, I went ahead with the replacement. Having replaced the belt a couple times in the past, I know the trick is to first mount the belt on the drive, and then on the brush cylinder while it is removed. Then position the opposite end of the brush cylinder in place, and then, using the already positioned end as a lever fulcrum, pull the brush cylinder down into position (it's tight) while at the same time rotating it so the mounting notch lines up. With some effort, it snapped in just fine, and has been working like a champ for a couple weeks.
Click to Editorial Reviews
No comments:
Post a Comment